Table of Contents
Advertisement
INSTALLATION AND OPERATION MANUAL
Enter "?" or "help" to list the commands
More detailed help for each command is available using help in front of the command
name.
Issuing a "netinfo" command will display the ip address of the switch
To change the network configuration using the CLI, the following commands must be used:
-setip
-setgw
-setdns
Save_netcfg if you want to save these changes in the startup configuration. Not using this
command will not save the changes persistently.
TECH SUPPORT: 1.888.678.9427
CNGE2+2SMS[POE][HO]
INS_CNGE2+2SMS_REV– 02/19/13 PAGE 50
Hide quick links:
Advertisement
Table of Contents
