INSTALLATION AND OPERATION MANUAL
Network Interface Configuration
Label
Host Name
Enable DHCP
IP Address
Gateway
Subnet Mask
Primary DNS
Secondary DNS
Apply
Important Note: A system reset must be performed after making changes to the network
settings.
TECH SUPPORT: 1.888.678.9427
Interface Configuration interface
Description
Assign a name to the device (this is used for CLI and SNMP functions)
To enable or disable the DHCP client function. When DHCP client
function is enabled, the switch will be assigned the IP address from the
network DHCP server. The default IP address will be replaced by the IP
address which the DHCP server has assigned.
Assign the IP address that the switch will use. If DHCP client Function is
enabled, you do not need to assign the IP address.
Assign the network gateway for the switch.
Assign the subnet mask for the switch.
Assign the primary DNS IP address
Assign the secondary DNS IP address
Select Apply to set the configurations.
CNGE2+2SMS[POE][HO]
INS_CNGE2+2SMS_REV– 02/19/13 PAGE 37