Poe Model Cnge2+2Smspoe And Cnge2+2Smspoeho - Comnet CNGE2+2SMS Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL

PoE Model CNGE2+2SMSPOE and CNGE2+2SMSPOEHO

Label Description
Enable Select to enable the active ping check function
Interval Active ping check interval in seconds
Remote IP Configure IP addresses of remote device to ping
Failure action Configure action to take upon failure
No Action - No action taken
SNMP Trap - Issue an SNMP trap
POE Reset - Reboot the PoE device
Trap & Reset - Issue an SNMP trap and then reboot the PoE device
Power Down - Turn off the RJ45 port
PwrDwn & Trap - Issue an SNMP trap and then turn off the RJ45 port
Retries Number of times to retry the ping check on failure before proceeding with the selected
failure action.
PoE Action PoE action to take
Reset Once - Reboot the PoE device once
Reset Forever - Reboot the PoE device forever until it comes back online
Power Down - Turn off the RJ45 port
If power down is selected for PoE action, the PoE power may be turned on remotely using the port
power up feature on the PoE-PSE status page.
TECH SUPPORT: 1.888.678.9427
CNGE2+2SMS[POE][HO]
INS_CNGE2+2SMS_REV– 02/19/13 PAGE 32