Upgrade Firmware - Comnet CNGE2+2SMS Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL

Upgrade Firmware

Upgrade Firmware allows you to update the firmware of the switch. Before updating, have your
Windows firmware update application ready and the firmware image is available. RSTP is not
available during the firmware update process so please, observe the network topology before
upgrading.
Details on how to upload the new image is located in Firmware Upgrade section on Page 51.
After applying a new firmware version, it is recommended that a Factory Default Reset is
performed to ensure that all new or adjusted settings take effect. Please note that performing a
Factory Default reset will erase all the devices settings except for the IP address.
Warning Do not enable the firmware update process unless you have a firmware file available
and are ready to upgrade the unit. Once this processed is started it cannot be cancelled
and if a new firmware is not uploaded to the unit it will be necessary to return the unit
to the factory for re-programming.
TECH SUPPORT: 1.888.678.9427
Update Firmware interface
CNGE2+2SMS[POE][HO]
INS_CNGE2+2SMS_REV– 02/19/13 PAGE 34