Initialisation - Danfoss vlt series Operating Instructions Manual

How to Configure the System

4.3 Initialisation

To achieve the best performance, initialise the frequency
converter after the option is mounted. If the frequency
converter is delivered from factory with the option
installed, skip this step. The initialisation is done via
14-22 Operation Mode or a 3 finger reset. The parameters
of the FC 302 are set to factory values, and a number of
FC 302 parameters are set to values that match the VLT
5000 initial values.
Parameter
0-02 Motor Speed Unit
1-52 Min Speed Normal Magnetising [Hz]
3-16 Reference Resource 2
4-12 Motor Speed Low Limit [Hz]
3-00 Reference Range
3-01 Reference/Feedback Unit
3-11 Jog Speed [Hz]
4-30 Motor Feedback Loss Function
4-56 Warning Feedback Low
4-57 Warning Feedback High
6-10 Terminal 53 Low Voltage
6-20 Terminal 54 Low Voltage
6-22 Terminal 54 Low Current
5-51 Term. 29 High Frequency
5-56 Term. 33 High Frequency
4-32 Motor Feedback Loss Timeout
14-21 Automatic Restart Time
14-03 Overmodulation
7-33 Process PID Proportional Gain
8-54 Reversing Select
8-90 Bus Jog 1 Speed
8-91 Bus Jog 2 Speed
7-04 Speed PID Differentiation Time
2-10 Brake Function
2-17 Over-voltage Control
5-40 Function Relay
5-41 On Delay, Relay
7-09 Speed PID Error Correction w/ Ramp
14-11 Mains Voltage at Mains Fault
MCB 101 option specific parameters
5-16 Terminal X30/2 Digital Input
5-17 Terminal X30/3 Digital Input
PROFIBUS specific parameters
9-71 Profibus Save Data Values
Table 4.5 Parameter Setup at Initialisation
®
VLT AutomationDrive FC 302 PROFIBUS Converter Operating Instructions
Factory copy via VLT
and initialises the FC 302 and also set it to the VLT
default settings.
The following parameters are set during the initialisation:
®
MG34N202 - Rev. 2013-10-15
®
5000 parameter 006 is supported
Initialisation setting
[Hz]
1.0 Hz
[0] No function
132.0 Hz
min – max
[1] %
10.0 Hz
[0] Disabled
-4000000
4000000
0.00 Volt
0.00 Volt
0.00 Volt
5000 Hz
25000 Hz
1.00 s
5 s
[0] Off
0.01
[0] Digital input
300 RPM
300 RPM
OFF
[0] Off
[0] Off
[22] Ready, no thermal Warning
[23] Remote, ready, no TW
100000 (max)
calculated value: VLT5000 level = FC 302 level
* 1,35 / sqrt(2)
[1] Reset
[19] Freeze reference
[1] Store all setups
®
5000
4 4
11