Procedure - Ametek 7230 Instruction Manual

Chapter 2, INSTALLATION AND INITIAL CHECKS

2.2.02 Procedure

2-2
good working order, not that it meets specifications. Each instrument receives a
careful and thorough checkout before leaving the factory, and normally, if no
shipping damage has occurred, will perform within the limits of the quoted
specifications. If any problems are encountered in carrying out these checks, contact
SIGNAL RECOVERY or the nearest authorized representative for assistance.
The procedure requires the use of a computer with an Ethernet 10 or 100 Base T
adaptor with RJ45 connector set to support TCP/IP protocol with an installed web
browser. As an example, a Windows 7 PC with Internet Explorer 11 is suitable, but
so are many other computer systems.
1) Check that the rear panel Config 1 and Config 2 switches are set to 0. This will
set the model 7230 to use the default static IP address of 169.254.150.230
2) Close all open programs on the computer and unplug any existing network
connection. Disable any wireless connection as well.
3) Plug one end of the supplied RJ45 patch cord to the computer and the other end
into the LAN connector on the rear panel of the model 7230
5) With the rear-panel mounted power switch set to 0 (off), plug the line cord into
the model PS0110 power supply unit and the 5-pin DIN plug on the power cable
from the PS0110 to the 7230's rear panel POWER INPUT connector.
6) Turn on the model 7230. The front panel status light should be green.
7) Open a browser session on the computer. Since there is no connection to the
internet you will not see the normal opening page, but an error message. If using
Internet Explorer on Windows 10 the message will be as shown in figure 2-2;
other browsers will generate similar messages.
8) Type 169.254.150.230 into the address bar and press <return>. The 7230's Main
Controls panel should be displayed, as shown below in figure 2-3.
Figure 2-2, Initial Browser Window