Ametek 7230 Instruction Manual page 119

IPADDR [n1 n2 n3 n4]
When this command is sent without parameters, the instrument responds with the
current IP address e.g. 169.254.0.10
When sent with the four parameters, the command sets the IP address that will be
used when the model 7230 is set to static IP address mode (via the rear panel Config
Switch 2, see section 4.2.07)
The parameters are separated by a space character and not by a dot, e.g.
IPADDR 169 254 0 10
sets the IP address to 169.254.0.10 Based on the IP address, this command will also
generate a default subnet mask and gateway address so if values other than the
defaults are required set the IP address before setting the subnet mask and gateway
address otherwise they will be overwritten.
SNMASK [n1 n2 n3 n4] Ethernet Subnet Mask
When this command is sent without parameters, the instrument responds with the
current subnet mask e.g. 255.255.0.0
When sent with the four parameters, the command sets the subnet mask that will be
used when the model 7230 is set to static IP address mode (via the rear panel Config
Switch 2, see section 4.2.07)
The parameters are separated by a space character and not by a dot, e.g.
SNMASK 255 255 0 0
sets the subnet mask to 255.255.0.0
Note that the setting can be overridden if the IP address is set using the IPADDR
command.
GWADDR [n1 n2 n3 n4] Ethernet Gateway Address
When this command is sent without parameters, the instrument responds with the
current gateway address e.g. 169.254.0.1
When sent with the four parameters, the command sets the gateway address that will
be used when the model 7230 is set to static IP address mode (via the rear panel
Config Switch 2, see section 4.2.07)
The parameters are separated by a space character and not by a dot, e.g.
GWADDR 169 254 0 1
sets the gateway address 169.254.0.1
Note that the setting can be overridden if the IP address is set using the IPADDR
command.
IPLOCK Restrict Ethernet Access
When this command is sent via the Ethernet interface, subsequent connection
requests and hence commands will only be accepted if sent from the same IP address,
preventing unauthorized access to the instrument.
IPUNLOCK Remove Ethernet Access Restrictions
When this command is sent via the Ethernet interface, subsequent connection
Chapter 6, COMPUTER OPERATION
Ethernet IP Address
6-33