Ametek 7230 Instruction Manual page 46

Chapter 5, WEB CONTROL PANEL OPERATION
5-4
11) Allow a few minutes for the router to be updated. After this, the DHCP server
page should show a single IP address – this will be address of the computer from
which you are accessing the router. In the above example the controlling
computer's IP address is 192.168.0.100, and the router's address (as shown, in
the address bar) is 192.168.0.254
12) Take the RJ45 patch cord and plug one end into the router and other into the
LAN connector of the rear panel of the model 7230.
13) Set the Config 2 switch on the rear panel of the model 7230 to position 1. This
will cause the instrument to be allocated an IP address by the DHCP server in the
router.
14) With the rear-panel mounted power switch set to 0 (off), plug the line cord into
the model PS0110 power supply unit and the 5-pin DIN plug on the power cable
from the PS0110 to the 7230's rear panel POWER INPUT connector.
15) Turn on the model 7230. The front panel status light should initially be green,
but will then flash red and green as it "counts out" the IP address it has been
allocated by the router. It is not necessary to wait until this finishes before
continuing.
16) Refresh the router's control DHCP control panel. The newly connected model
7230 will now appear as a second entry in the table:
Figure 5-4, Router DHCP Status Page