Equations: Overview; Equations: Equation 1 And Equation 2 - Ametek 7230 Instruction Manual

5.3.26 Equations: Overview

The Equations panel, shown above in Figure 5-42, allows the two user equations that
are built in to the instrument to be defined, as well as giving access to a Command
Interface that allows instrument commands to be sent to the unit and the response, if
any, displayed.

5.3.27 Equations: Equation 1 and Equation 2

The Equation 1(shown above in figure 5-43) and Equation 2 controls are used to
define more complex calculations on the instrument outputs than are possible using
the basic ratio and log ratio options. Each equation takes the following form:-


Equation =

where the operator "±" may be set to either addition or subtraction, and the variables
A, B, C and D can be chosen from the following list:-
Chapter 5, WEB CONTROL PANEL OPERATION
Figure 5-42, Equations
Figure 5-43, Equation 1
 

(A B) C


D
5-41