Ametek 7230 Instruction Manual page 50

Chapter 5, WEB CONTROL PANEL OPERATION
5-8
10) In the Command input box type
IPADDR XXX XXX XXX XXX
where XXX XXX XXX XXX is the static IP address given to you by your
network administrator. Note that there are no periods (full stops) between the
digit groups. So if, for example, you were given an IP address of 10.150.11.2,
type IPADDR 10 150 11 2 as shown in figure 5-10, and press <return>.
11) Once this is done, communications will immediately be lost and an error
message, similar to that shown in figure 5-11, will be shown:
Figure 5-9, Model 7230 Equations Panel
Figure 5-10, Entering New IP Address