Main Controls: Display Indicators - Ametek 7230 Instruction Manual

5.3.02 Main Controls: Display Indicators

Each of the four digital indicators along the bottom of the screen can be set to
display the following instrument outputs (see figure 5-18).
Output Description
X1
X1 channel output. In Single Reference mode this is the X output
Y1
Y1 channel output. In Single Reference mode this is the Y output
Mag1
Resultant (Magnitude1) output. In Single Reference mode this is the Mag
output
Phase1
Phase1 output. In Single Reference mode this is the Phase output
Noise1
Noise output for the first demodulator.
X2
X2 channel output, valid only in when demodulator 2 is active
Y2
Y2 channel output, valid only in when demodulator 2 is active
Mag2
Resultant (Magnitude2) output, valid only in when demodulator 2 is
active
Phase2 Phase2 output, valid only in when demodulator 2 is active
Eqn1 Output value of User Equation 1
Eqn2 Output value of User Equation 2
If an output is in overload, the display is shown in red text (figure 5-19).
Chapter 5, WEB CONTROL PANEL OPERATION
Figure 5-18, Selecting Instrument Outputs
Figure 5-19, Output Overload Indication
5-15