Modem Switch Settings - Bosch Access Easy Controller 2.1 Hardware Installation Manual

Access Easy Controller 2.1
4.
5.
15.2.1

Modem Switch Settings

Switch
1
2
3
4
5
6
7
8
1.
Robert Bosch (SEA) Pte Ltd
Connect one end of the telephone cable provided with the modem to the wall jack and
the other end into the connector on the back of the modem. There are two connectors on
the back of the modem. Be sure to connect the cable to the incoming phone line
connector. This connector may be labelled "incoming line" or there may be a drawing of a
phone jack to indicate the proper connector.
Depending on the model of the modem, some has switches on the back or the side, the
table below acts as a guide for the type of settings that is needed. Refer to the modem
manual for more information.
Setting Function
OFF Data Terminal Ready (DTR) Override
–
–
OFF Verbal/Numeric Result Codes
–
–
ON Result Code Display
–
–
OFF Command Mode
Echo Suppression
–
–
OFF Auto-Answer Suppression
–
–
OFF Carrier Detect (CD) Override
–
–
OFF Power-on and ATZ Reset Software Defaults
–
–
ON AT Command Set Recognition
–
–
Power up the modem using the off/on switch located on the front. The AA, TR, and CS
indicators should light. All others should be off.
Hardware Installation Manual
OFF - Normal DTR operations: computer must provide DTR
signal for the modem to accept comment; dropping DTR
terminates a call
ON - Modem ignores DTR (Override)
OFF - Verbal (word) results
ON - Numeric results
OFF - Suppresses result codes
ON - Enables result codes
OFF - Displays keyboard commands
ON - Suppresses echo
OFF - Modem answers on first ring, or higher if specified in
NVRAM
ON - Disable auto-answer
OFF- Modem sends CD signal when it connects with
another modem, drops CD on disconnect
ON - CD always ON (Override)
OFF - Loads Y0-Y4 configuration from user-defined non-
volatile memory (NVRAM)
ON - Loads & FO - Generic template from read-only memory
(ROM)
OFF - Disables command recognition (Dumb Mode)
ON - Enables recognition (Smart Mode)
Dial-In Networking | en 87
2018.11 | 1.0.6 | F.01U.122.796