Address Setting Switch; Factory Default Setting - Bosch Access Easy Controller 2.1 Hardware Installation Manual

Table of Contents

Advertisement

30
en | 4-Reader Board
6.1.12

Address Setting Switch

Reference: SW1
SW1 is switch to set the address of individual interface boards. It consists of two dip switches
for setting of the address in binary sequence. Each AEC2.1 can manage up to eight 4-Reader
boards and eight 8-IO boards. The address settings for the 4-Reader boards are shown in the
table below.
Address setting using SW1 for
the 1
AEC2.1 system.
Address setting using SW1 for
the 2
AEC2.1 system.
Address setting using SW1 for
the 3
AEC2.1 system.
Address setting using SW1 for
the 4
AEC2.1 system.
Notice!
The boards are addressed in binary sequence. AEC2.1 can support up to 16 interface boards,
eight 4-Reader boards and eight 8-IO boards. The address pin '1' is reserved for future
development, to expand the capability of AEC2.1.
6.1.13

Factory Default Setting

Reference: JP2
JP2 of the first 4-Reader board is used to reset the AEC2.1 back to factory default. JP2 carries
two functions:
2018.11 | 1.0.6 | F.01U.122.796
st
and 5
th
4-Reader board in
nd
th
and 6
4-Reader board in
rd
and 7
th
4-Reader board in
th
and 8
th
4-Reader board in
Clearing all information, settings and configuration. (IP address will not be reset with this
function)
Resetting the IP address of the panel back to default IP
Hardware Installation Manual
ON
The 1
consist of readers 1 to 4
The 5
1
2
3
consist of readers 17 to 20
The 2
ON
consist of readers 5 to 8
The 6
consist of readers 21 to 24
1
2
3
The 3
consist of readers 9 to 12
The 7
ON
consist of readers 25 to 28
The 4
1
2
3
consist of readers 13 to 16
The 8
consist of readers 29 to 32
ON
1
2
3
Access Easy Controller 2.1
st
4-Reader board will
th
4-Reader board will
nd
4-Reader board will
th
4-Reader board will
rd
4-Reader board will
th
4-Reader board will
th
4-Reader board will
th
4-Reader board will
Robert Bosch (SEA) Pte Ltd

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aec-aec21-ext1Apc-aec21-ups1

Table of Contents