Operating Principle; Switch On And Switch Off - Bosch AVENAR panel 8000 Manual

20 pt-BR | Operating principle
5

Operating principle

5.1

Switch on and switch off

Power button
The fire panel must be switched on and off with a power button which is located at the right
side of the panel. Also a reboot of the panel is done via the power button.
Advertência!
Don't unplug the panel for restarting it! Always use the power button. Unplugging the running
!
panel can cause a serious damage of the hardware and software.
The functions of the power button are:
–
–
Aviso!
A confirmation sound is played when the shutdown-sequence is starting. The shutdown is
i
completed when the "general fault"
up. Wait until the shutdown is completed before you interrupt the power.
Aviso!
i
After having shut down the panel please interrupt the power supply. If a panel was shut down
but is not unplugged, after 10 seconds a warning tone will sound as a reminder.
–
Advertência!
You must only use this way of interrupting the panel if the system does not react anymore or
!
if you are asked to do so in case the panel ran into the safe state.
Safe state
2023-08 | 8.0 | F.01U.378.877
Press once shortly: Start the panel
Press once shortly at a running panel: Shut down the panel
Press for 8 seconds: Interrupt the panel and reboot it (for example in case of a software
failure).
and the "system/panel fault"
Manual do utilizador
AVENAR panel 8000 | AVENAR panel 2000 |
AVENAR keypad 8000
status LEDs light
Bosch Sicherheitssysteme GmbH