86
en | Dial-In Networking
2.
Notice!
AEC2.1 only supports US Robotics dial-in Modems. For other brands of modem, refer to dial-
in protocol section to check modem compatibility.
3.
2018.11 | 1.0.6 | F.01U.122.796
The diagrams below indicate the location of the controller's serial port that is connected
to the modem.
Connect cable from the 9-volt transformer supplied with the modem into the connector
on the back of the modem. Leave the modem powered off at this time.
Hardware Installation Manual
Access Easy Controller 2.1
Serial COM Port 2 for connecting to
Modem
Robert Bosch (SEA) Pte Ltd