Table of Contents
Advertisement
Access Easy Controller 2.1
Notice!
There is an additional setting available which is the Door Buzzer. When a reader is configured
as an Entry and Arm/Disarm reader, the buzzer control for the reader will need to be rewired
to a spare output on the 4-Reader board. See the wiring diagram below for an example on
Reader1 wired as an Entry and Arm/Disarm reader.
9.
10. You need to configure the cardholder to be able to arm/disarm the reader. Refer to
11. The section below shows the wiring requirement of Entry and Arm/Disarm Reader for a
Notice!
Refer the software manual for more information on the door settings.
Robert Bosch (SEA) Pte Ltd
Complete the rest of the setup as per a normal door access reader.
AEC2.1 software manual for configuring an Arm/Disarm card.
HID reader.
Hardware Installation Manual
Entry and Arm/Disarm Reader | en
2018.11 | 1.0.6 | F.01U.122.796
99
Advertisement
Table of Contents
Need help?
Do you have a question about the Access Easy Controller 2.1 and is the answer not in the manual?