Access Easy Controller 2.1
Notice!
AEC2.1 uses RS485 multi-drop communication channels between the interface boards. An
end-of-line jumper is to be added on the last interface board of the configuration to stabilize
the communication.
The figure below shows the inter-connection of the Main Controller panel.
Figure 11.2: Inter-connection of the components within the main controller panel
Inserting Compact Flash onto the AEC2.1 CPU
Robert Bosch (SEA) Pte Ltd
How to Install the Access Easy Controller 2.1 | en
1. Position the Compact Flash in the correct
orientation.
2. Slot in the Compact Flash as shown.
Hardware Installation Manual
61
2018.11 | 1.0.6 | F.01U.122.796