Cellular Receiver 1 Options - DSC LE4000 Installation Manual

Table 10: Panel Tamper Alarm Restore
Event
[033] Comm. FW
Update Begin
[034] Comm. FW
Update Successful
[035] Panel FW Update
Begin
[036] Panel FW Update
Successful
[037] Panel FW Update
Fail
C R
ELLULAR ECEIVER
[201] Cellular Receiver 1 Account Code
Default (0000000000)
The account code is used by the central station to distinguish between transmitters. This
account code is used when transmitting heartbeat signals to the central station receiver. Signals
received from the control panel use the control panel account number. Valid range:
0000000001 - FFFFFFFFFE. Programming all 0 or all F causes a Module Configuration
Trouble (yellow LED = 12 flashes).
[202] Cellular Receiver 1 DNIS
Default (000000)
The DNIS is used in addition to the account code to identify the Communicator module at the
central station. Valid range: 000000 - 099999. Values are entered as leading 0 followed by the
5-digit DNIS. Format is BCD.
NOTE: Each Cellular receiver must be programmed with a unique DNIS.
[203] Cellular Receiver 1 Address
Default (000.000.000.000)
Enter the Cellular Receiver 1 IP address. This information is provided by your central station
system administrator. Each 3-digit segment of the address must be within a valid range of 000-
255.
NOTE: When a valid IP address has been entered, the Cellular is enabled and communicates
events over the Cellular channel.
[204] Cellular Receiver 1 Port
Default (0BF5/3061)
This section determines the port used by Cellular Receiver 1. Change the default value of this
port when your installation is located behind a firewall, and must be assigned a particular port
number as determined by your central station system administrator. Valid range: 0000 - FFFF.
NOTE: Programming this section with 0000 disables the receiver.
[205] Cellular Receiver 1 APN
Default ( )
The Access Point Name (APN) determines the Cellular network that the Communicator
connects to. This information is available from your network carrier. Program this Section as
32 ASCII characters.
NOTE: When a SIM card with a custom APN is used, the unit cannot access the Internet.
DLS and remote flash can still be done if section [221] is programmed with a valid
Public APN.
SIA
SIA
Reporting
Identifier
Code
LB 00
LS 00
LB 00
LS 00
LU 00
1 O
PTIONS
Contact
Contact
ID
ID
Event
Qualifier
Code
1 9
3 9
1 9
3 9
1 9
18
Contact Contact
ID ID
Reporting User/
Code Zone
03 002
03 002
03 003
03 003
04 003