Brother BAS-341H Instruction Manual page 27

Operator
Green and yellow wire
(ground wire)
BAS-341H, BAS-342H
Connect cords that match the voltage
specifications.
<200 V system >
(1) Power switch
(2) Wood screws [2 pcs.]
3146B
(3) 3-pin power supply connector
3583B
(4) Power cord
(5) Staples [5 pcs.]
1. Attach an appropriate plug to the
power cord (4). (The green and yellow
wire is the ground wire.)
2. Insert the power
properly-grounded electrical outlet.
NOTE:
• Take care when tapping in the staples
(5) to make sure that they do not pierce
the cords.
• Do not use extension cords, otherwise
machine operation
result.
3. Use the eight screws to tighten the
cover of the control box. Check that
none of the cords are being clamped
by the cover at this time.
3. INSTALLATION
plug into a
problems may
18