Setting 2-Step Operation For The Work Clamp - Brother BAS-341H Instruction Manual

4. PREPARATION BEFORE SEWING

4-8. Setting 2-step operation for the work clamp

1st step
2nd step
Intermediate
1st step
position
2nd step
31
When these settings are made, the work clamp (1) can be
4009M
lowered in two steps.
1. Set memory switch No. 002 to "1".
(Refer to "2-2. List of memory switch settings" in the "LCD
Panel/Operation Panel" Instruction Manual.)
2. With the work clamp (1) raised, loosen the wing screw (2).
3. Move the work clamp stopper (3) up or down to determine
the intermediate position, and then tighten the wing screw
(2) to secure the work clamp stopper (3) in place.
4. Depress the work clamp switch (4) to the 1st step and
check the intermediate position for the work clamp.
5. Depress the work clamp switch (4) to the 2nd step to fully
lower the work clamp.
* 2-step work clamp operation is enabled when memory
switch No. 002 is set to "1".
* Do not set memory switch No. 002 to "2".
4010M
<To return the work clamp to one-step operation>
1. Set memory switch No. 002 to "0".
(Refer to "2-2. List of memory switch settings" in the "LCD
Panel/Operation Panel" Instruction Manual.)
2. With the work clamp (1) raised, loosen the wing screw (2).
3. Move the work clamp stopper (3) to its highest position,
and then tighten the wing screw (2) to secure the work
clamp stopper (3) in place.
4011M
BAS-341H, BAS-342H