Replacing The Movable And Fixed Knives - Brother BAS-341H Instruction Manual

Direct drive programmable electronic pattern sewer
Hide thumbs Also See for BAS-341H:
Table of Contents

Advertisement

7. STANDARD ADJUSTMENTS

7-11. Replacing the movable and fixed knives

1.
Loosen the two bolts (1) and then remove the feed plate (2).
2.
Open the shuttle race cover, remove the two screws (3) and the two flat screws (4), and then remove the needle plate (5).
3.
Remove the movable knife (6) and the fixed knife (7).
5003Q
4. Install the new fixed knife (7) in the position shown in the illustration.
5. Apply grease to the outside of the collar (8) and to the shoulder screw (9), and then install the new movable knife (6)
together with the thrust washer (10) and the movable knife spacer (11).
6. Check that the movable knife (6) and fixed knife (7) cut the thread cleanly. Replace the movable knife spacer with
accessory spacers (t=0.2, 0.3, 0.4) so that the knives trim the thread accurately.
* If the knife pressure is too weak and the thread is not completely cut, use a thinner movable knife spacer.
* If the knife pressure is too strong and the movable knife (1) turns stiffly, use a thicker movable knife spacer.
7. Apply grease to the pin (12), place it into the movable knife connecting plate (13), and install it to the needle plate (5).
8. Check that the needle is aligned with the center of the needle hole.
9.
Install the feed plate (2). (Refer to the next page.)
43
BAS-341H, BAS-342H
4044M
4045M

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bas-342h

Table of Contents