Parameter Menu (M2) - Vacon NX Active Front End User Manual

Control Keypad
RUN
Lo cal
Monitor
V1
Code Signal name
Frequency reference
V1.1
DC-link voltage
V1.2
Unit temperature
V1.3
Voltage input
V1.4
Current input
V1.5
DIN1, DIN2, DIN3
V1.6
DIN4, DIN5, DIN6
V1.7
DO1, RO1, RO2
V1.8
Analogue output current
V1.9
Multimonitoring items
M1.17
6.3.2

Parameter menu (M2)

Parameters are the way of conveying the commands of the user to Vacon
Parameter values can be edited by entering the Parameter Menu from the Main Menu when the
location indication M2 is visible on the first line of the display. The value editing procedure is
presented in Figure 56.
Menu button right
Pressing
parameter group by using the
and it's parameters. Use the
Menu button right takes you to the edit mode. As a sign of this, the parameter value starts to blink.
You can now change the value in two different ways:
24-hour support +358 (0)201 212 575 • Email: vacon@vacon.com
READY

V14
Figure 55. Monitoring menu
Table 25. Monitored signals
Unit
Hz
V Measured DC-link voltage
ºC Heat sink temperature
V AI1
mA AI2
Digital input statuses
Digital input statuses
Digital and relay output statuses
mA AO1
Displays three selectable monitoring values. See
Chapter 6.3.8.4, Multimonitoring items (P6.5.4).
once takes you to the Parameter Group Menu (G#). Locate the desired
Browser buttons
Browser buttons
to find the parameter (P#) you want to edit
RUN
Lo ca l
FreqReference
13.95 Hz
RUN
Lo cal
Output frequency
13.95 Hz
Description
Menu button right
and press
vacon • 77
R EADY
READY
11204.emf
®
NX Active Front End.
again to see the group
.
Pressing
6