Vacon NX Installation Manual
Fr7 ip54 kit
Hide thumbs
Also See for NX:
- User manual (239 pages) ,
- Service manual (113 pages) ,
- Installation manual (10 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Vacon NX
Summary of Contents for Vacon NX
- Page 1 ® ac drives fr7 ip54 kit installation manual...
- Page 3 • 1 TABLE OF CONTENTS Document ID: DPD01914 Revision: A Revision release date: 30.12.2016 1. Introduction ........................ 2 1.1. Kit contents ........................... 2 2. Installation instructions....................3 Local contacts: http://drives.danfoss.com/danfoss-drives/local-contacts/...
-
Page 4: Kit Contents
• 2 Introduction NTRODUCTION Using these instructions, you can enhance the enclosure protection class of your IP21 class AC drive to IP54. A higher protection level may be necessary when the AC drive is used in ambient conditions which might constitute a risk for the proper functioning of the AC drive (moist, dust). -
Page 5: Installation Instructions
Installation instructions vacon • 3 NSTALLATION INSTRUCTIONS Remove the IP21 front cover by removing the two M4x60 and two M4x50 mounting screws. Use a PZ2 bit. Remove the conduit plate by removing the six M5x10 screws and the two M4x8 screws. Use a PZ2 bit. - Page 6 • 4 Installation instructions Install the two GD9 bushing rubbers (E) in the two open holes. Install the IP54 internal fan assembly (C) on the power unit cover. Use the three M4x6 screws (I) to mount the IP54 internal fan assembly. Use a PZ2 bit and tighten the screws to torque 2.4 Nm.
- Page 7 Installation instructions vacon • 5 Push the four M4x60 screws (K) through the holes on the IP54 front cover (A). Install the four O-rings (F) on the screws (K). Install the IP54 front cover (A) on the AC drive. Use a PZ2 bit and tighten the four screws to torque 1.5 Nm.
- Page 8 Document ID: Vacon Ltd DPD01914A Member of the Danfoss Group Rev. A Runsorintie 7 65380 Vaasa Finland...