Table 9: Aiccu Tunnels; Table 10: Gre Tunnels - Grandstream Networks GWN7000 User Manual

6rd IPv4 Peer
Enter the IPv4 Peer address.
Address
6rd IPv6 Address Specifies the IPv6 prefix given by the provider.
Prefix Example: 2001:B000::/32
Specifies the IPv6 prefix length (Value between 1 and 128).
IPv6 Prefix Length
Example: 32
Specifies the prefix length of the IPv4 transport address.
IPv4 Prefix Length
(Value between 1 and 32).
WAN Interface Choose the WAN port on which to setup the aiccu tunnel.
Username Enter the Username (Provided by signing up with SixXS Tunnel Broker)
Password Enter the Username's password
WAN Interface Specifies the WAN interface to bind the tunnel to.
Name Set a name for the tunnel connection.
Enabled Enabled/Disable the tunnel connection.
GRE Peer IP Address Specifies the tunnel destination address (public IP).
GRE Tunnel IP
Specify the local GRE tunnel interface. (ex: 10.1.1.2)
Address
GRE Tunnel Netmask Set the Tunnel interface netmask. (ex: 255.255.255.0)
Configures the maximum transmission unit. The valid range is 64-9000 and the
MTU
default is 1500.
Subnet Set the destination subnet that is reachable though GRE tunnel.
Enable/Disable IP masquerading. Users could configure this option under the
IP Masquerading
"General" tab of Firewall → Advanced as well.
Tunnel Input Key Specifies the key that would be added to the incoming packets.
Tunnel Output Key Specifies the key that would be added to the outgoing packets.

Table 9: AICCU Tunnels

Table 10: GRE Tunnels

GWN7000 User Manual
Version 1.0.6.28
P a g e |
32