Net Port; Tunnel; Table 6: Net Port; Table 7: 6In4 Tunnels - Grandstream Networks GWN7000 User Manual

NET Port

This page allows for the configuration of NET port, which can be used either as LAN port or WAN port.
Below are the available options to configure the NET port.
Enable LAN1 (NET
Enable the NET port as a normal LAN port.
Port)
Enable the NET port as a WAN port, and set the required configuration as WAN1
Enable WAN (Net
and 2. See Table 5: GWN7000 WEB GUI
Port)

Tunnel

Tunnel page is used to set IPv6 tunnels on WAN ports via IPv6 tunnel brokers service providers, this serves
the purpose of transferring IPv6 packets over IPv4 Network. It supports creating 6in4, 6rd, AICCU and GRE
tunnels. Please refer to below tables for each tunnel type.
WAN Interface Choose the WAN port on which to setup the 6in4 tunnel.
Set the Maximum Transmission Unit value.
MTU
The valid range is 64-9000. Default value is 1500.
6in4 IPv4 Peer
Enter the IPv4 tunnel endpoint at the tunnel's provider.
Address
6in4 Tunnel Endpoint Enter the local IPv6 address delegated to the tunnel endpoint.
IPv6 Address Example: 2001:db8:2222::2/64
Set the routable prefix given by the tunnel provider to allow LAN clients to get
6in4 Routed Prefix
addresses from that prefix.
Tunnel ID Specifies the tunnel's ID.
Username Set the username used to login into the tunnel broker.
Password Set the password (used for endpoint update).
Update Key Set the update key, it overrides the password used for endpoint update.
WAN Interface Choose the WAN port on which to setup the 6rd tunnel.
Set the Maximum Transmission Unit value.
MTU
The valid range is 64-9000 and default value is 1500.

Table 6: NET Port

Table 7: 6In4 Tunnels

Table 8: 6rd Tunnels

GWN7000 User Manual
Version 1.0.6.28
→ → →
Router WAN WAN Port (1,2)
P a g e |
31