Global Settings; Table 7: 6Rd Tunnels; Table 8: Aiccu Tunnels - Grandstream Networks GWN7000 User Manual

Default value is 1500.
6in4 IPv4 Peer
Enter the IPv4 tunnel endpoint at the tunnel's provider.
Address
6in4 Tunnel Endpoint Enter the local IPv6 address delegated to the tunnel endpoint.
IPv6 Address Example: 2001:db8:2222::2/64
Set the routable prefix given by the tunnel provider to allow LAN clients to get
6in4 Routed Prefix
addresses from that prefix.
Specifies the tunnel's ID.
Tunnel ID
Set the username used to login into the tunnel broker.
Username
Password Set the password (used for endpoint update).
Update Key Set the update key, it overrides the password used for endpoint update.
Choose the WAN port on which to setup the 6rd tunnel.
WAN Interface
Set the Maximum Transmission Unit value.
MTU The valid range is 64-9000.
Default value is 1500.
6rd IPv4 Peer
Enter the IPv4 Peer address.
Address
6rd IPv6 Address Specifies the IPv6 prefix given by the provider.
Example: 2001:B000::/32
Prefix
Specifies the IPv6 prefix length (Value between 1 and 128).
IPv6 Prefix Length
Example: 32
Specifies the prefix length of the IPv4 transport address.
IPv4 Prefix Length
(Value between 1 and 32).
WAN Interface Choose the WAN port on which to setup the aiccu tunnel.
Username Enter the Username (Provided by signing up with SixXS Tunnel Broker)
Enter the Username's password
Password

Global Settings

This section specifies operating mode for multi-WAN that will be used for enabling/disabling Failover and
Load Balancing on WAN ports, and banning MAC addresses.
The following table shows the configuration parameters for Multi-WAN settings

Table 7: 6rd Tunnels

Table 8: aiccu Tunnels

GWN7000 User Manual
P a g e | 25