Table 41: Dnat - Grandstream Networks GWN7000 User Manual

Refer to below table when creating or editing a DNAT entry:
Name
Enabled
IP Family
Source Group
Destination Group
Protocol
Source IP
Rewrite IP
Destination IP
Schedule Start Date
Schedule End Date
Schedule Start Time
Schedule End Time
Schedule Weekdays List of
Weekdays
Schedule Days of the Month
Treat Time Values as UTC
Instead of Local Time
Enable NAT Reflection

Table 41: DNAT

Specify a name for the DNAT entry
Check to enable this DNAT entry.
Select the IP version, three options are available: IPv4, IPv6 or Any.
Select a WAN interface or a LAN group for Source Group, or select All.
Select a WAN interface or a LAN group for Destination Group, or select
All. Make sure that destination and source groups are different to avoid
conflict.
Select one of the protocols from dropdown list or All, available options
are: UDP, TCP, TCP/UCP and All.
Set the Source IP address.
Set the Rewrite IP. The source IP address of the data package from the
source group will be updated to this configured IP.
Set the Destination IP address.
Click on icon to schedule a start date for this DNAT entry to be
applied.
Click on icon to schedule an end date for this DNAT entry to end.
Click on icon to schedule a start time for this DNAT entry to be
applied.
Click on icon to schedule an end time for this DNAT entry to end.
Select the days, on which the DNAT entry will be applied, the unselected
days will ignore this rule.
Enter the days of the months (separated by space) on which the DNAT
entry will be applied.
Example: 5 10 15
This will be applied only on 5
Check to use UTC as time zone for the specified times, instead of using
GWN7000's local time.
Check to enable NAT Reflection for this DNAT entry to allow the access
of a service via the public IP address from inside the local network.
GWN7000 User Manual
Version 1.0.6.28
, 10 and 15 day monthly.
th th th
P a g e |
118