A device connected to one of the allowed network groups to the shared files can use the following path for
access:
\\GWN_Address\Share_Name\
Share_Name is the Share Name created for the File Share. It is also possible to map a network drive on
Windows, or use a Samba client on Linux machine.
SNMP
GWN7000 supports SNMP (Simple Network Management Protocol) which is widely used in network
management for network monitoring for collecting information about monitored devices.
To configure SNMP settings, go to GWN7000 Web GUI→System Settings→SNMP, this page has two
tabs: Basic and Advanced, refer to the below tables for each tab.
System Location
Set the System Location information, for example: SNMP-Server Lobby GWN.
Set the System Contact information, for example: Contact Supervisor_GWN via
System Contact
extension is 1000.
System Name
Set the System Name information, for example: Supervisor_GWN.
Read-Only
Gives the permission for the set community to access and read only to devices in
Community for IPv4
management information base via IPv4 Protocol.
Where GWN_Address is the GWN7000 IP address, and
Figure 97: Access File Share
Table 54: SNMP Basic Page
GWN7000 User Manual
Version 1.0.6.28
P a g e
|
150