Ports Configuration; Wan Ports Settings; Table 5: Gwn7000 Web Gui -> Router ->Port -> Wan Port (1,2) - Grandstream Networks GWN7000 User Manual

Ports Configuration

Connect to GWN7000's Web GUI from a computer connected to a LAN port and go to Router->Port page
for Port configuration.

WAN Ports Settings

The GWN7000 has 2 WAN ports configured as DHCP clients by default. Each port can be connected with
DSL modem or routers.
WAN ports support also setting static IPv4/IPv6 addresses, and configure PPPoE for each WAN port.
Please refer to the following table for basic network configuration parameters on WAN ports for GWN7000.
Choose whether to enable or disable the WAN port.
Enabled
Select "DHCP", "Static" or "PPPoE" mode on the WAN interfaces of GWN7000.
The default setting is "DHCP".
•
•
WAN Address Type
•
Enter the preferred DNS server address (IPv4 address). If Preferred DNS is set,
Preferred IPv4 DNS
GWN7000 will use it in priority.
Enter the Alternate DNS server address (IPv4 address). If Preferred DNS is set,
Alternate IPv4 DNS
GWN7000 will use it in when the Preferred DNS fails.
Used to enable assigning IPv6 address to GWN7000.
Once checked users will be able to configure following fields: "IPv6 Address
Native IPv6
Assignment", "Preferred IPv6 DNS", "Alternate IPv6 DNS" and "IPv6 Relay to
LAN".
This option is appearing when enabling "Native IPv6" option.
Select "Auto" to get an IPv6 address from DHCP server or "Static" to configure
manually an IPv6 address. If set to Static, the following fields should be
IPv6 Address
configured:
Assignment
•
Table 5: GWN7000 WEB GUI -> Router ->Port -> WAN Port (1,2)
DHCP
When selected, it will act as a DHCP client and acquire an IPv4 address
automatically from the DHCP server.
Static
When selected, the user should set a static IPv4 address, Subnet Mask, IPv4
Gateway and adding Additional IPv4 Addresses as well.
PPPoE
When selected, the user should set the PPPoE account and password,
PPPoE Keep alive interval and Inter-Key Timeout (in seconds).
IPv6 Address/Prefix Length
Used to set an IPv6 address/Prefix length when using Static IPv6 option
GWN7000 User Manual
P a g e | 23