Dnat; Table 32: Dnat - Grandstream Networks GWN7000 User Manual

Schedule Start Time
Schedule End Time
Schedule Weekdays List of
Weekdays
Schedule Days of the Month
Treat Time Values as UTC
Instead of Local Time

DNAT

Following actions are available for DNAT:
•
To add new DNAT entry, click on
•
To edit a DNAT entry, click on
•
To delete a DNAT rule, click on
Refer to below table when creating or editing a DNAT entry:
Name
Enabled
IP Family
Source Group
Destination Group
Protocol
Source IP
Rewrite IP
Destination IP
Click on icon to schedule a start time for this SNAT entry to be
applied.
Click on icon to schedule an end time for this SNAT entry to end.
Select the days, on which the SNAT entry will be applied, the unselected
days will ignore this rule.
Enter the days of the months (separated by space) on which the SNAT
entry will be applied.
Example: 5 10 15
This will be applied only on 5
Check to use UTC as time zone for the specified times, instead of using
GWN7000's local time.
.
.
.

Table 32: DNAT

Specify a name for the DNAT entry
Check to enable this DNAT entry.
Select the IP version, three options are available: IPv4, IPv6 or Any.
Select a WAN interface or a LAN group for Source Group, or select All.
Select a WAN interface or a LAN group for Destination Group, or select
All. Make sure that destination and source groups are different to avoid
conflict.
Select one of the protocols from dropdown list or All, available options
are: UDP, TCP, TCP/UCP and All.
Set the Source IP address.
Set the Rewrite IP. The source IP address of the data package from the
source group will be updated to this configured IP.
Set the Destination IP address.
GWN7000 User Manual
th th th
, 10 and 15 day monthly.
P a g e | 77