Driving Range; Average Speed; Total Idling Stop Time - Suzuki IGNIS Series 2016 Owner's Manual

BEFORE DRIVING
To change when the value of average fuel
consumption is reset, refer to "Setting
mode" in this section.
NOTE:
If you add only a small amount of fuel
when you select "Reset after refuel", the
average fuel consumption value may not
be reset.

Driving range

If you selected driving range the last time
you drove the vehicle, the display indicates
"---" for a few seconds and then indicates
the current driving range when the ignition
switch is turned to "ON" position or the
engine switch is pressed to change the
ignition mode to ON.
The driving range shown in the display is
the approximate distance you can drive
until the fuel gauge indicates "E", based on
current driving conditions.
When the low fuel warning light comes on,
the display "---" will appear.
If the low fuel warning light comes on, fill
the fuel tank immediately regardless of the
value of driving range shown in the display.
As the driving range after refueling is cal-
culated based on the most recent driving
condition, the value is different each time
you refuel.
2-75
NOTE:
• If you refuel when the ignition switch is in
"ON" position or the ignition mode is ON,
the driving range may not indicate the
correct value.
• When you reconnect the negative (–)
terminal to the lead-acid battery, the
value of driving range will be shown after
driving for a period of time.

Average Speed

If you selected average speed the last time
you drove the vehicle, the display indicates
the last value of average speed from previ-
ous driving when the ignition switch is
turned to "ON" position or the engine
switch is pressed to change the ignition
mode to ON. Unless you reset the value of
average speed, the display indicates the
value of average speed which includes
average speed during previous driving.
To reset the value of average speed, push
and hold the information switch (2) for a
while when the display indicates an aver-
age speed. The display shows "---" and
then indicates a new average speed after
driving for a short time.
NOTE:
When you reconnect the negative (–) ter-
minal to the lead-acid battery, the value of
average speed will be shown after driving
for a period of time.
Driving time
The display shows the total amount of driv-
ing time since the indication was reset.
• To reset the driving time to zero, push
and hold the information switch (2) for a
while when the display shows the driving
time.
NOTE:
When you reset the indication or reconnect
the negative (–) terminal to the lead-acid
battery, the driving time will be shown after
driving for a while.
Total idling stop time (if equipped)
The display shows the total length (in
hours, minutes and seconds) of engine
stopping time by ENG A-STOP system
since the indication was reset.
• To reset the total idling stop time to zero,
push and hold the information switch (2)
for a while when the display shows the

total idling stop time.

NOTE:
• The indicated maximum value of the total
idling stop time is 99:59:59.
• When you reconnect the negative (–)
terminal to the lead-acid battery, the
value of the total idling stop time will be
reset.
75RM0-01E