Table of Contents
Advertisement
NOTE:
• CVT – If the gearshift lever is in any
position other than "P", or if the knob but-
ton is pushed when the gearshift lever is
in "P" position the ignition mode cannot
be returned to LOCK (OFF).
• When selecting the ignition modes, the
information display in the instrument
cluster shows certain messages. Refer
to "Information display" in the "BEFORE
DRIVING" section for details.
If the master warning indicator light
blinks and the ignition modes cannot
be selected
Your keyless push start system remote
controller may not be sensed as being
within the interior workable area (refer to
the related explanation in this section). Try
again after checking that you have the
remote controller with you. If the ignition
modes still cannot be selected, the battery
of the remote controller may be dis-
charged. To select an ignition mode, you
must then use the following method:
EXAMPLE
(1)
(2)
58MST0302
1) Without depressing the brake pedal
and the clutch pedal, push the engine
switch (1).
2) The master warning indicator light in
the instrument cluster blinks and the
message
"PLACE
KEY
FOB
START SWITCH" appears on the infor-
mation display within about 10 sec-
onds. Touch the engine switch with
LOCK button end of remote controller
(2) for about 2 seconds.
OPERATING YOUR VEHICLE
NOTE:
• If you still cannot select the ignition
modes, there may be some problem with
the keyless push start system. Contact
an authorized SUZUKI dealer for an
inspection of the system.
• The immobilizer/keyless push start sys-
tem warning light will come on for about
5 seconds while the master warning indi-
cator light is blinking. In addition, the
information display in the instrument
cluster will show a message during this
time. Refer to "Information display" in the
"BEFORE DRIVING" section for details.
• You may customize the system to cause
the interior buzzer to sound once for
warning that remote controller is out of
sensing range. To incorporate this cus-
tomization, please contact an authorized
SUZUKI dealer.
• If the battery of the remote controller is
ON
about to become completely discharged,
the corresponding message will appear
on the information display when you
press the engine switch to change the
ignition mode to ON. Refer to "Informa-
tion display" in the "BEFORE DRIVING"
section for details. For details on replac-
ing the battery, refer to "Keyless push
start system remote controller / keyless
entry
system
transmitter"
"BEFORE DRIVING" section.
in
the
3-8
75RM0-01E
Advertisement
Table of Contents
