Table of Contents
Advertisement
BEFORE DRIVING
Light reminder buzzer
The interior buzzer continuously beeps if
you open the driver's door without turning
off the headlights and position lights. This
function is triggered under the following
condition:
The headlights and/or position lights are
on even after the ignition switch is turned
off, or the engine switch is pressed to
change the ignition mode to LOCK (OFF).
The buzzer stops sounding when you turn
off the headlights and position lights.
NOTE:
A message is indicated on the information
display in the instrument cluster with
tachometer while the buzzer is sounding.
Daytime running light (D.R.L.) sys-
tem (if equipped)
When the engine is started, this system
turns on the daytime running lights.
Conditions for D.R.L. system operation
1) The engine is running.
2) Headlights and front fog light (if
equipped) are off.
NOTE:
Brightness of the daytime running lights is
different from the brightness of the position
lights, but it is not a malfunction.
2-117
Guide me light (if equipped)
To home function
This function turns on the front position
lights and the headlights in the low beam
setting for about 10 seconds after the igni-
tion switch is turned to "LOCK" position or
the engine switch is pressed to change the
ignition mode to LOCK (OFF).
To set the function:
1) Turn the lighting switch to "AUTO" posi-
tion
2) Turn the ignition switch to "LOCK" posi-
tion or press the engine switch to
change the ignition mode to LOCK
(OFF).
3) Pull the lighting control lever toward
you once and open the driver's side
door within 60 seconds. Or pull the
lighting control lever toward you once
while the driver's side door is open.
To cancel the function:
Perform any of the following operations.
• Pull the lighting control lever toward you
once.
• Insert the key into the ignition switch or
change the ignition mode to ACC or ON
by pressing the engine switch.
• Turn the lighting switch to any other
position than "AUTO" position.
NOTE:
• When the "To home" is functioning, the
front fog lights, rear fog lights and the
headlights (high beam) are not turned
on.
• Lighting time of the "To home" function
can be changed on the information dis-
play. Refer to "Information display" in this
section.
To car function
If UNLOCK button of the keyless push start
system remote controller or the keyless
entry system transmitter is pressed while
the lighting switch is positioned in "AUTO",
the front position lights and the headlights
in the low beam are turned on for 10 sec-
onds.
This function will operate only when it is
dark outside the vehicle.
To cancel the function:
Perform any of the following operations.
• Lock the doors by using the keyless
push start system remote controller, the
request switch or the keyless entry sys-
tem transmitter, or insert the key into the
driver's door lock.
• Insert the key into the ignition switch
change the ignition mode to ACC or ON
by pressing the engine switch.
• Turn the lighting switch to any other
position than "AUTO" position.
75RM0-01E
Advertisement
Table of Contents
