Starting The Engine; Clutch Operation; Creeping Function - Suzuki IGNIS Series 2016 Owner's Manual

Starting the engine

When starting the engine, always place the
gearshift lever in the "N" position and
depress the brake pedal firmly. The engine
cannot be started unless the gearshift
lever is in the "N" position and the brake
pedal is depressed.
If you parked vehicle with gear engaged on
last time (if you can see "1" or "R"), shift
into "N" (Neutral) and depress the brake
pedal. Hold the brake pedal while starting
the engine. You can hear buzzer in short
time.
NOTE:
If you start the engine without the gearshift
lever in the "N" position, the gear position
indicator in the instrument cluster will blink.

Clutch operation

You can select either the Drive (D) mode or
the Manual (M) mode. Since this vehicle
controls clutch operation electronically in
either mode, you do not need to operate
the clutch.

Creeping function

This vehicle has a creeping function that
helps the vehicle to start smoothly by
engaging the clutch. When the gearshift
lever is in any of the positions "D", "M" or
"R", and you release your foot from the
brake pedal, the vehicle starts slowly with-
out depressing the accelerator pedal. The
creeping function is disabled if you
depress the brake pedal or pull up the
parking brake lever.
NOTE:
If the driver's door is opened and/or the
parking brake lever is engaged with the
gear in the "M", "D" or "R" position, the
creeping function will not operate.
Parking and Stopping the vehicle
Auto Gear Shift does not have a parking
position. Park the vehicle with a gear
engaged. Make sure that the gearshift
lever is "D", "M", or "R".
Also, check the instrument cluster to make
sure that the transaxle is engaged in "1" or
"R" position.
NOTICE
A buzzer will sound continuously if
the vehicle is operated with the gear-
shift lever in-between of each shift
positions. The vehicle will become
inoperative if you continue to operate
the vehicle with the gearshift lever in-
between shift positions.
OPERATING YOUR VEHICLE
Drive (D) mode
When the Drive (D) mode is activated, the
most appropriate gear position is automati-
cally selected upon operation of the accel-
erator pedal and variation of vehicle
speed.
Normal driving:
1) Start the engine as instructed in "Start-
ing the engine" in this section.
2) With your foot on the brake pedal, shift
the gearshift lever to the "D" position.
When the gearshift lever is shifted to
the "D" position, the gear will be shifted
to 1st.
NOTE:
• If 1st gear cannot be engaged even
though the gearshift lever has been
shifted from the "N" to the "D" position,
the system will re-try shifting automati-
cally. This will take some time, noise
may be heard from the gears, and shift-
ing gear shock may occur. However,
they do not indicate malfunction.
• The "N" indicator will flush, the depress
brake pedal indicator will come on and a
warning buzzer (long pulse sound) will
sound if any of the following cases
occur;
– If you shift the gearshift lever from the
"N" to the "D" position without depress-
ing the brake pedal
– If the system is unable to re-try shifting
You should depress the brake pedal and
shift the gearshift lever to "N" position,
then shift to "D" again.
75RM0-01E
3-26