Table of Contents
Advertisement
If the master warning indicator light
blinks and the engine cannot be started
Your keyless push start system remote
controller may not be sensed as being
within the interior workable area. Try again
after checking that you have the remote
controller with you. If the engine still can-
not be started, the battery of the remote
controller may be discharged. To start the
engine, use the following method:
EXAMPLE
(1)
(2)
58MST0302
1) Check that the parking brake is set fully.
2) Manual transaxle – Shift to "N" (Neutral)
and fully depress the clutch pedal. Hold
the clutch and brake pedals fully
depressed.
CVT – If the gearshift lever is not in the
"P" (Park) position, shift it to "P". Hold
the brake pedal fully depressed.
Auto Gear Shift – Shift to "N" (Neutral)
and fully depress the brake pedal. Hold
the brake pedal fully depressed.
3) "PUSH START SWITCH." message will
appear on the information display in the
instrument cluster. Press the engine
switch (1).
4) The master warning indicator light in
the instrument cluster blinks within
about 10 seconds. Touch the engine
switch with LOCK button end of remote
controller (2) for about 2 seconds.
NOTE:
• If you still cannot start the engine after
several
attempts
using
the
method, there may be a problem else-
where, such as the lead-acid battery per-
formance is poor. Contact your SUZUKI
dealer for inspection.
• The immobilizer/keyless push start sys-
tem warning light will come on for about
5 seconds while the master warning indi-
cator light is blinking. In addition, the
information display will show a certain
message during this time. Refer to
"Information display" in the "BEFORE
DRIVING" section for details.
• You may customize the system to cause
the interior buzzer to sound once for
warning that remote controller is out of
sensing range. Please contact an autho-
rized SUZUKI dealer for the customiza-
tion.
OPERATING YOUR VEHICLE
• If the battery of the remote controller is
about to become completely discharged,
the corresponding message will appear
on the information display when you
press the engine switch to change the
ignition mode to ON. For details on
replacing the battery, refer to "Keyless
push start system remote controller /
keyless entry system transmitter" in the
"BEFORE DRIVING" section.
above
3-16
75RM0-01E
Advertisement
Table of Contents
