Table of Contents
Advertisement
(3)
(8)
5) Remove the plug from the filler hose (3)
and insert the filler hose into the tire
valve (8).
(2)
6) Hold the bottle (2) with bottom upwards
and pump the bottle to fill the entire bot-
tle contents (sealant) into the tire.
Thereafter pull off the filler hose and
firmly screw the valve insert into the tire
valve again. If the valve insert is dirty or
lost, use the enclosed spare valve
insert.
10 min. Max.
(10)
81PN248
required
air pressure
(1)
(8)
7) Screw the air hose (10) of the compres-
sor (1) to the tire valve (8). Fit the
power plug (11) to the accessory
socket. Start the engine. Switch on the
compressor. Inflate the tire to the
required air pressure.
63J349
EMERGENCY SERVICE
WARNING
Do not stand by the tire, when inflat-
ing. It can burst.
NOTICE
Do not operate the compressor for
longer 10 minutes without cease. It
can cause overheating of the com-
pressor.
(11)
If the tire cannot be inflated to the required
air pressure within 5 minutes, move the
vehicle a few meters back and forth to
spread the sealant over the entire tire.
Then, inflate the tire again.
If the tire still cannot be inflated to the
required air pressure, the tire may be
severely damaged. In this case, the flat tire
repair kit cannot provide the necessary
81PN120
seal. Consult a SUZUKI dealer or a road-
side assistance service.
NOTE:
If the tire is over-inflated, deflate air by
loosening the screw of the air hose.
8-8
75RM0-01E
Advertisement
Table of Contents
