Changing Wheels - Suzuki IGNIS Series 2016 Owner's Manual

NOTE:
For more details, contact an authorized
SUZUKI dealer.

Changing wheels

To change a wheel, use the following pro-
cedure:
1) Remove the jack (if equipped), tools
and spare wheel from the vehicle.
2) Loosen, but do not remove the wheel
nuts.
3) Jack up the vehicle (follow the jacking
instructions in this section).
WARNING
• Be sure to shift into "P" (Park) in
CVT, or shift into "R" (Reverse) in
manual transaxle/Auto Gear Shift
when you jack up the vehicle.
• Never jack up the vehicle with the
transaxle in "N" (Neutral). Other-
wise, unstable jack may cause an
accident.
4) Remove the wheel nuts and wheel.
(1)
(2)
(3)
(4)
5) Clean any mud or dirt off from the sur-
face of the wheel (1), hub (2), thread
part (3) and surface of the wheel nuts
(4) with a clean cloth. Clean the hub
carefully; it may be hot from driving.
6) Install the new wheel and replace the
wheel nuts with their cone shaped end
facing the wheel. Tighten each nut
snugly by hand until the wheel is
securely seated on the hub.
EMERGENCY SERVICE
Tightening torque for wheel nut
85 Nm (8.7 kg-m, 62.7 lb-ft)
7) Lower the jack and fully tighten the nuts
with a wrench in numerical order as
shown in the illustration.
WARNING
Use genuine wheel nuts and tighten
65J4033
them to the specified torque as soon
as possible after changing wheels.
Incorrect wheel nuts or improperly
tightened wheel nuts may come
loose or fall off, which can result in
an accident. If you do not have a
torque wrench, have the wheel nut
torque checked by an authorized
SUZUKI dealer.
54G116
8-4
75RM0-01E