5
Troubleshooting
2
3
98
Set up the stimulus board
a Configure the oscillator select switch S1 according to the following settings:
•
S1 0 (Off).
•
S2 1 (On).
•
S3 0 (Off).
•
Int.
b Configure the data mode switch S4 according to the following settings:
•
Even.
•
Count.
c Press the Resynch VCO button, then the Counter RST (Counter Reset) button.
In the Keysight Logic and Protocol Analyzer application, choose File→New. This puts the logic
analysis system into its initial state.
Pod 1
Pod 4
connector
Pod 5
connector
Keysight 16860 Series Portable Logic Analyzers Service Guide
Pod 2