Siemens SCALANCE W1750D UI Configuration Manual page 148

Wired Profiles
12.1 Configuring a Wired Profile
– Spanning Tree—Select the Spanning Tree check box to enable Spanning Tree
– Inactivity Timeout—Specify the time out interval within the range of 60–86,400
5. Click Next. The VLAN tab details are displayed.
6. Configure VLAN for the wired profile. For more information, see Configuring VLAN for a
Wired Profile (Page 149).
In the CLI
To configure the settings for a wired profile:
(scalance)(config)# wired-port-profile <name>
(scalance)(wired ap profile <name>)# type {<employee>|<guest>}
(scalance)(wired ap profile <name>)# speed {10|100|1000|auto}
(scalance)(wired ap profile <name>)# duplex {half|full|auto}
(scalance)(wired ap profile <name>)# no shutdown
(scalance)(wired ap profile <name>)# poe
(scalance)(wired ap profile <name>)# uplink-enable
(scalance)(wired ap profile <name>)# content-filtering
(scalance)(wired ap profile <name>)# spanning-tree
(scalance)(wired ap profile <name>)# end
(scalance)# commit apply
148
as Uplink port. For more information on assigning a wired network profile to a port, see
Assigning a Profile to Ethernet Ports (Page 155).
Protocol (STP) on the wired profile. STP ensures that there are no loops in any
bridged Ethernet network and operates on all downlink ports, regardless of forwarding
mode. STP will not operate on the uplink port and is supported only on APs with three
or more ports. By default, Spanning Tree is disabled on wired profiles.
seconds for inactive wired clients. The default interval is 1000 seconds.
Configuration Manual, 02/2018, C79000-G8976-C451-02
SCALANCE W1750D UI