Siemens SCALANCE W1750D UI Configuration Manual page 85

Parameter
Console access
Telnet server
LED display
Extended SSID
Deny inter user bridging
Deny local routing
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
Description
When enabled, you can access the AP through the
console port.
To start a Telnet session with the AP CLI, enable
access to the Telnet server.
LED display status of the AP. To enable or disable
LED display for all APs in a cluster, select Enabled or
Disabled, respectively.
NOTE: The LEDs are always enabled during the AP
reboot.
Extended SSID is enabled by default in the factory
default settings of APs. This disables mesh in the
factory default settings.
The Access Point supports up to 14 SSIDs when
Extended SSID is disabled and up to 16 SSIDs with
Extended SSID enabled.
If you have security and traffic management policies
defined in upstream devices, you can disable bridging
traffic between two clients connected to the same AP
on the same VLAN. When inter user bridging is de-
nied, the clients can connect to the Internet but cannot
communicate with each other, and the bridging traffic
between the clients is sent to the upstream device to
make the forwarding decision.
By default, the Deny inter user bridging parameter is
disabled.
If you have security and traffic management policies
defined in upstream devices, you can disable routing
traffic between two clients connected to the same AP
on different VLANs. When local routing is disabled,
the clients can connect to the Internet but cannot
communicate with each other, and the routing traffic
between the clients is sent to the upstream device to
make the forwarding decision.
By default, the Deny local routing parameter is disa-
bled.
Initial Configuration Tasks
7.1 Configuring System Parameters
CLI Configuration
(scalance)(config)
# console
(scalance)(config)
# telnet-server
(scalance)(config)
# led-off
(scalance)(config)
# extended-ssid
(scalance)(config)
# deny-inter-user- bridging
To disable inter-user bridging for
the WLAN SSID clients:
(scalance)(config)
# wlan ssid-profile
<ssid-profile>
(scalance)(SSID Profile
<ssid- profile>)# deny- in-
ter-user-bridging
(scalance)(config)
# deny-local-routing
85