Adding An Ap To The Network - Siemens SCALANCE W1750D UI Configuration Manual

Customizing AP Settings

8.8 Adding an AP to the Network

8.8 Adding an AP to the Network
To add an AP to the SCALANCE W network, assign an IP address. For more information,
see Assigning an IP address to the AP (Page 30).
After an AP is connected to the network, if the Auto-Join feature is enabled, the AP inherits
the configuration from the VC and is listed in the Access Points tab.
If the auto-join mode is disabled, perform the following steps by using the SCALANCE W UI.
In the SCALANCE W UI:
To add an AP to the network:
1. On the Access Points tab, click the New link.
2. In the New Access Point window, enter the MAC address for the new AP.
3. Click OK.
98
Configuration Manual, 02/2018, C79000-G8976-C451-02
SCALANCE W1750D UI