Siemens SCALANCE W1750D UI Configuration Manual page 427

Configuring PPPoE Uplink Profile
You can configure PPPoE settings from the SCALANCE W UI or the CLI.
In the SCALANCE W UI
Configuring PPPoE settings:
1. Click the System link on the SCALANCE W main window.
2. In the System section, click the Show advanced options link.
3. Perform the following steps in the PPPoE section in the Uplink tab:
– Enter the PPPoE service name provided by your service provider in the Service name
– Enter the secret key used for Challenge Handshake Authentication Protocol (CHAP)
– Enter the username for the PPPoE connection in the User text box.
– Enter a password for the PPPoE connection and confirm the password in the
4. Select a value from the Local interface drop-down list to set a local interface for the
PPPoE uplink connections. The selected DHCP scope will be used as a local interface on
the PPPoE interface and the Local, L3 DHCP gateway IP address as its local IP address.
When configured, the local interface acts as an unnumbered PPPoE interface and allows
the entire Local, L3 DHCP subnet to be allocated to clients.
Note
The options in the Local interface drop-down list are displayed only if a Local, L3 DHCP
scope is configured on the AP.
5. Click OK.
6. Reboot the AP for the configuration to take effect.
In the CLI
To configure a PPPoE uplink connection:
(scalance)(config) # pppoe-uplink-profile
(scalance)(pppoe-uplink-profile)# pppoe-svcname <service-name>
(scalance)(pppoe-uplink-profile)# pppoe-username <username>
(scalance)(pppoe-uplink-profile)# pppoe-passwd <password>
(scalance)(pppoe-uplink-profile)# pppoe-chapsecret <password>
(scalance)(pppoe-uplink-profile)# pppoe-unnumbered-local-l3-dhcp-profile <dhcp-
profile>
(scalance)(pppoe-uplink-profile)# end
(scalance)# commit apply
To view the PPPoE configuration:
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
text box.
authentication in the CHAP secret and Retype text boxes. You can use a maximum of
34 characters for the CHAP secret key.
Password and Retype text boxes.
Uplink Configuration
26.2 Ethernet Uplink
427