Configuring Vlan For A Wired Profile - Siemens SCALANCE W1750D UI Configuration Manual

12.1.2

Configuring VLAN for a Wired Profile

Note
If you are creating a new wired profile, complete the Wired Settings procedure before
configuring the VLAN settings. For more information, see Configuring Wired Settings
(Page 147).
You can configure VLAN using the SCALANCE W UI or the CLI.
In the SCALANCE W UI
To configure a VLAN:
1. In the VLAN tab, enter the following information.
Mode—You can specify any of the following modes:
– Access—Select this mode to allow the port to carry a single VLAN specified as the
– Trunk—Select this mode to allow the port to carry packets for multiple VLANs
Specify any of the following values for Client IP Assignment:
– Virtual Controller Assigne: Select this option to allow the VC to assign IP addresses to
– Network Assigned: Select this option to allow the clients to receive an IP address from
If the Trunk mode is selected:
– Specify the VLAN in Allowed VLAN, enter a list of comma separated digits or ranges,
– If is set to , specify a value for Native VLAN. A VLAN that does not have a VLAN ID
If the Access mode is selected:
– If Client IP Assignment is set to Virtual Controller Assigned, proceed to step 2.
– If Client IP Assignment is set to Network Assigned, specify a value for Access VLAN
2. Click Next. The Security tab details are displayed.
3. Configure security settings for the wired profile. For more information, see Configuring
Security Settings for a Wired Profile (Page 151).
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
native VLAN.
specified as allowed VLANs.
the wired clients. When the VC assignment is used, the source IP address is
translated for all client traffic that goes through this interface. The VC can also assign
a guest VLAN to a wired client.
the network to which the VC is connected. On selecting this option, the New button to
create a VLAN is displayed. Create a new VLAN if required.
for example, 1,2,5 or 1–4, or all. The Allowed VLAN refers to the VLANs carried by the
port in Access mode.
tag in the frames is referred to as Native VLAN. You can specify a value within the
range of 1–4093.
to indicate the VLAN carried by the port in the Access mode.
Wired Profiles
12.1 Configuring a Wired Profile
149