Ap Maintenance; Upgrading An Ap - Siemens SCALANCE W1750D UI Configuration Manual

AP Maintenance

31.1

Upgrading an AP

Upgrading to a New Version Manually
If the Automatic Figure Check feature is disabled, you can obtain an image file from a local
file system or from a TFTP or HTTP URL.
To manually check for a new firmware image version and obtain an image file:
1. Navigate to Maintenance > Firmware.
2. Under Manual section, perform the following steps:
– Select the Figure file option. This method is only available for single-class APs.
– Select the Figure URL option. Select this option to obtain an image file from a TFTP,
3. Clear the Reboot all APs after upgrade check box if required. The Reboot all APs after
upgrade check box is selected by default to allow the APs to reboot automatically after a
successful upgrade. To reboot the AP at a later time, clear the Reboot all APs after
upgrade check box.
4. Click Upgrade Now to upgrade the AP to the newer version.
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
FTP, or HTTP URL.
- HTTP - http://<IP-address>/<image-file>.
- TFTP - tftp://<IP-address>/<image-file>.
- FTP - ftp://<IP-address>/<image-file>
31
471