Siemens SCALANCE W1750D UI Configuration Manual page 173

SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
Parameter
Uppercase support
WISPr
(Applicable for WLAN SSIDs
only.)
Auth server 1
Auth server 2
Load balancing
Reauth interval
Blacklisting
(Applicable for WLAN SSIDs
only.)
Accounting mode
(Applicable for WLAN SSIDs
only)
Accounting interval
Encryption
(Applicable for WLAN SSIDs
only.)
13.4 Configuring Internal Captive Portal for Guest Network
Description
Set to Enabled to allow the AP to use uppercase letters in MAC
address string for MAC authentication.
NOTE: This option is available only if MAC authentication is ena-
bled.
Select Enabled if you want to enable WISPr authentication. For
more information on WISPr authentication, see Configuring WISPr
Authentication on page 173.
NOTE: The WISPr authentication is applicable only for Internal-
Authenticated splash pages and is not applicable for wired pro-
files.
Select any one of the following:
A server from the list of servers, if the server is already config-
•
ured.
Internal Server to authenticate user credentials at run time.
•
Select for configuring a new external RADIUS or LDAP server
•
for authentication.
Select Enabled to enable load balancing if two authentication
servers are used.
Select a value to allow the APs to periodically reauthenticate all
associated and authenticated clients.
If you are configuring a wireless network profile, select Enabled to
enable blacklisting of the clients with a specific number of authen-
tication failures.
Select an accounting mode from the Accounting mode drop-down
list for posting accounting information at the specified accounting
interval. When the accounting mode is set to Authentication, the
accounting starts only after client authentication is successful and
stops when the client logs out of the network. If the accounting
mode is set to Association, the accounting starts when the client
associates to the network successfully and stops when the client
is disconnected.
Configure an accounting interval in minutes within the range of 0–
60, to allow APs to periodically post accounting information to the
RADIUS server.
Select Enabled to configure encryption parameters. Select an
encryption and configure a passphrase.
Captive Portal for Guest Access
173