Siemens SCALANCE W1750D UI Configuration Manual page 139

Beacon Report Requests and Probe Responses
The beacon request frame is sent by an AP to request a client to report the list of beacons
detected by the client on all channels.
● The beacon request is sent using the radio measurement request action frame.
● It is sent only to those clients that have the capability to generate beacon reports. The
clients indicate their capabilities through the
association request frames.
● By default, the beacon request frames are sent at a periodicity of 60 seconds.
Configuring a WLAN SSID for 802.11k Support
You can enable 802.11k support on a WLAN SSID by using the SCALANCE W UI or the
CLI.
In the SCALANCE W UI
1. Navigate to the WLAN wizard (Go to Network > New OR Go to Network > WLAN SSID
and click edit).
2. Click the Security tab.
3. Under Fast Roaming, select the 802.11k check box.
4. Click Next and then click Finish.
Note
To allow the AP and clients to exchange neighbor reports, ensure that Client match is
enabled through RF > ARM > Client match > Enabled in the UI or by executing the client-
match command in the arm configuration subcommand mode.
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
11.2 Configuring Fast Roaming for Wireless Clients
RRM enabled capabilities IE
Wireless Network Profiles
sent in the
139