Siemens SCALANCE W1750D UI Configuration Manual page 111

3. Based on the type of network profile, select any of the following options under Primary
usage:
– Employee
– Voice
– Guest
4. Click the Show advanced options link. The advanced options for configuration are
displayed. Specify the following parameters as require:
Parameter
Broadcast filtering
Multicast transmission optimization
Dynamic multicast optimization
SCALANCE W1750D UI
Configuration Manual, 02/2018, C79000-G8976-C451-02
11.1 Configuring Wireless Network Profiles
Description
Select any of the following values:
All—When set to All, the AP drops all broadcast and
•
multicast frames except DHCP and ARP, IGMP group
queries, and IPv6 neighbor discovery protocols.
ARP—When set to ARP, the AP drops all broadcast and
•
multicast frames except DHCP and ARP, IGMP group
queries, and IPv6 neighbor discovery protocols; addition-
ally, it converts ARP requests to unicast and send frames
directly to the associated client. The broadcast filtering
option is set to ARP by default when an SSID profile is
created.
Unicast-ARP-Only—When set to Unicast-ARP-Only, the
•
AP allows all broadcast and multicast frames as it is,
however the ARP requests are converted to unicast
frames and sends them to the associated clients.
Disabled—When set to Disabled, all broadcast and mul-
•
ticast traffic is forwarded to the wireless interfaces.
Select Enabled if you want the AP to select the optimal rate
for sending broadcast and multicast frames based on the
lowest of unicast rates across all associated clients. When
this option is enabled, multicast traffic can be sent at up to 24
Mbps. The default rate of sending frames for 2.4 GHz is 1
Mbps and that for 5 GHz is 6 Mbps. This option is disabled
by default.
Select Enabled to allow the AP to convert multicast streams
into unicast streams over the wireless link. Enabling Dynamic
Multicast Optimization (DMO) enhances the quality and reli-
ability of streaming video, while preserving the bandwidth
available to the non-video clients.
NOTE: When you enable DMO on multicast SSID profiles,
ensure that the DMO feature is enabled on all SSIDs config-
ured in the same VLAN.
Wireless Network Profiles
111