Table of Contents
Advertisement
Chapter 2 Preparations
Installing PCI board in the primary/secondary riser
Read the following notes first.
Please prepare the following before installing the options.
Parts included in the option kit
To install the components, follow these steps.
1.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
Raise the screw handles located on the upper part of the riser card and turn it 180°. To the left. Pick up the
both end part of the primary riser card and lift them up to remove.
Important
When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
Note
Check the card type which respective riser card supports and the type of PCI
card to be installed.
Important
To prevent personal injury, electrical shock or equipment damage, unplug
the power cord and ensure no power is supplied to the server. You cannot
turn off the system power supply completely by the power button on the
front panel. Until the AC power cord is unplugged, the power supply circuit
is still active in some parts of the machine.
Note
When running a server, always ensure proper cooling by attaching the top
cover, baffle, expansion slot cover, and blank. If the server supports
components with hot-plug support, minimize the amount of time the top cover is
open.
Express5800/R120h-2M (3rd-Gen) User's Guide
1. Installing Internal Optional Devices
105
Advertisement
Table of Contents
