Turning On The Server - NEC Express5800 Series User Manual

Chapter 3 Setup
1.

Turning on the Server

Pressing POWER Switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
1. Turn on a display, an Uninterruptible Power Supply (UPS), and other peripherals.
2. Remove Front Bezel
3. When the STATUS lamp flashes green (once per second), wait until the lamp lights in steady state.
4. Press POWER Switch at the front of the server.
POWER LED flashes green (once per second) and after a while, logo appears on the display.
・2.5-inch drive model
144
Note
If the power cord is connected with the power supply control unit such as
uninterruptible power supply (UPS), make sure that the power supply control unit is
turned ON.
Important
Do not connect/disconnect USB devices during POST execution.
Express5800/R120h-1E User's Guide
1. Turning on the Server
POWER Switch