NEC Express5800 Series User Manual page 137

Chapter 2 Preparations
Removal procedure
●
Remove the server from the rack in the following procedure.
1. Make sure that the server is turned off and then disconnect the power cord or all interface cables from the
server.
2. Remove the front bezel.
3. Open the lids of the unit fixing screws on both sides of the device. Then remove the fixing screws inside
with Hexalobular screwdriver, if the device is screwed on. If the device is not screwed on, you can unlock
the device just by opening the lid.
4. Slide the unit forward, and remove from the rack while holding it securely. In case the unit is locked in the
middle, continue pushing the rail stopper on the side of the rail and slowly draw out the unit to remove from
the rack.
Important
At least two persons are required to remove the server from rack.
Important
Be careful not to get your fingers caught in the rails or lever.
Important
While more than one person is supporting the bottom part of the server,
●
slowly pull out the server.
Do not apply pressure on the server from top when it is being pulled out.
●
Doing so cause the server to drop.
Express5800/R120h-1E User's Guide
2. Installation and Connection
137